Skip to content
The Bonsai Art

Beginner's guide · 盆栽の部位

The parts of a bonsai

Learning to look at a bonsai means learning its parts. Tap a number to jump to its explanation.

Pl. IBonsai anatomy
  1. 1

    Apex

    atama · 頭

    The highest part of the tree, where the trunk ends. It sets the final height and closes the silhouette.

    What is valued
    A rounded apex leaning slightly towards the front, suggesting a mature tree rather than a pointed young sapling.
    How it is developed
    It is the most vigorous zone: pinch and prune here earlier and harder than below to balance the tree's strength.
  2. 2

    Foliage pads

    The masses of leaves or needles at the end of each branch, like stepped clouds.

    What is valued
    Pads separated by air, flatter below and denser above, letting the trunk show through.
    How it is developed
    They are shaped by pinching and selective pruning; thinning the inside lets light in and keeps inner branches alive.
  3. 3

    Ramification

    The network of fine twigs that divide again and again inside each pad.

    What is valued
    Short, ever finer divisions, in pairs (bifurcation), with no crossing branches or branches turning back to the trunk.
    How it is developed
    It is the result of years of pinching and cutting shoots back to one or two leaves. In deciduous trees it shows best in winter.
  4. 4

    First branch

    ichi no eda · 一の枝

    The lowest and thickest branch. It usually sits about a third of the way up the trunk.

    What is valued
    It should grow to one side (not towards the front), be thicker than those above and give the composition visual stability.
    How it is developed
    It is left to grow freely to thicken and then cut back. It is the first branch chosen when designing a tree.
  5. 5

    Back branch

    ushiro eda · 後ろ枝

    A branch growing backwards, behind the trunk when seen from the front.

    What is valued
    It gives depth: without it the tree looks flat, like a drawing in profile.
    How it is developed
    When designing, keep at least one back branch between the first and second side branches.
  6. 6

    Jin

    jin · 神

    A dead, stripped branch kept as deadwood, bleached by the sun.

    What is valued
    It should look natural, the result of lightning or storms, and tell of the tree's age and hard life.
    How it is developed
    It is created by stripping the bark from a surplus branch and protected with lime sulphur. Typical of junipers and pines.
  7. 7

    Shari

    shari · 舎利

    A strip of deadwood along the trunk with live bark around it.

    What is valued
    It should follow the trunk's movement and coexist with well-defined live veins.
    How it is developed
    It is opened little by little over several seasons, following the sap lines so the branches are not weakened.
  8. 8

    Trunk, taper and movement

    miki · 幹

    The axis of the tree. Taper is how it narrows from base to apex; movement is its curves.

    What is valued
    A trunk that thins progressively, with old bark and curves that soften as it rises. The first few centimetres (tachiagari) are watched most closely.
    How it is developed
    Thickness is gained in the ground or a large pot by letting sacrifice branches grow; movement is given with wire while the trunk is young.
  9. 9

    Nebari

    nebari · 根張り

    The surface roots spreading from the base of the trunk over the soil.

    What is valued
    Thick roots fanning out in every direction without crossing, giving the tree a solid, ancient base.
    How it is developed
    It is built at every repotting: radial roots are combed out and placed, and crossing or vertical roots are removed.
  10. 10

    Soil and moss

    The mineral mix the roots live in and the layer of moss covering it.

    What is valued
    Soil that drains in seconds and fine, low moss that suggests a meadow without hiding the nebari.
    How it is developed
    Sift the soil before use and refresh the moss before showing the tree; remove it if it makes watering harder.
  11. 11

    Pot

    hachi · 鉢

    The container and, at the same time, the tree's frame.

    What is valued
    Its shape, colour and size should accompany the tree without competing: about two thirds of its height in length.
    How it is developed
    It is chosen at the end of the design; while the tree develops, a large training pot is better.
  12. 12

    Front

    shōmen · 正面

    The viewpoint from which the tree looks best. It is not a physical part, but it decides everything.

    What is valued
    From the front you see the best nebari, the trunk leans slightly towards the viewer and no branch points straight at them.
    How it is developed
    Turn the tree slowly before any major pruning and choose the front first: the rest of the design depends on it.